Solutions to several common installation defects of rubber conveyor belts

When using rubber conveyor belts, you should always consider protecting the use of rubber conveyor belts so that they can be better used in production. The storage and transportation of rubber conveyor belts should pay attention to the correct method, which can greatly increase the service life of the conveyor belt. At the same time, you should also pay attention to the installation process to provide you with an effective solution:

1. The installation length of the rubber conveyor belt is inappropriate
Whether it is new belt installation or old belt replacement, if the installation of the entire conveyor belt is not carefully planned and calculated beforehand, it is easy to cause the conveyor belt to extend, and the direct result is the counterweight (weight hammer) Hit the ground, causing the start to slip. Although there were no problems at the time and no problems with the test drive, some of them were configured in a low position. After two or three months of operation, the counterweight sags and hits the ground when starting. This is because the plastic deformation and elastic deformation of the conveyor belt were not considered during the installation process.
The conveyor belt should not be too short during installation, and a certain margin should be left for future maintenance. If the length is basically in the small part of the spiral tension. After using for a period of time, there is a problem with the joint, and the conveyor belt has insufficient margin, and the joint cannot be redone, so a new belt has to be reinstalled. This causes our conveyor belt to cause a waste of nothing. At the same time, enterprises suffer certain unnecessary losses. This is a situation we don't want to see in production.
The ideal conveyor belt installation situation is that the length of the conveyor belt is moderate after installation (we should consider the difference in the effect of temperature on the expansion rate of the conveyor belt in summer and winter), so that a margin for the joint can be reserved.

2. The quality of the joint is not good enough
The supervision of the joint glue connection of the conveyor belt is an important part of the conveyor belt installation process. The quality of the joints directly affects the normal operation of the conveyor. Band-breaking accidents caused by quality problems of vulcanized joints occur from time to time, which not only affects production, but also causes personal injury. The quality of the joint is reflected in the use effect. If the temporary control is not strengthened during the bonding process, it is difficult to see the problem only by the completion acceptance. Therefore, it is important to strictly control the quality of the vulcanized joint during the conveyor belt installation process.